1)Fe_(78)Si_9B_(13)Fe78Si9B13
1.Investigation of the force between atoms by Mssbauer spectrum technology and brittleness by relative rupture-strain measurement has been done after amorphous Fe_(78)Si_9B_(13) alloy is tread by different ultra-short pulsing current.改变超短电脉冲电流条件,对电脉冲处理后的非晶Fe78Si9B13用Mo¨ssbauer谱方法进行了原子间力研究,用相对断裂应变法进行了脆性研究。
2.The specimens of the alloy Fe_(78)Si_9B_(13) after such a treatment were observed by Mssbauer spectroscopy and TEM.低频脉冲磁场处理是一种崭新的非热处理型非晶纳米晶化的方法·针对非晶合金Fe78Si9B13进行了低频脉冲磁场处理,用M ssbauer谱仪、透射电子显微镜观察处理后样品的微观结构变化·研究表明,低频脉冲磁场可促进非晶合金Fe78Si9B13发生纳米晶化,在所用脉冲磁场参数下,晶粒尺寸为2~10nm,且试样温升小于20℃·结合脉冲磁场参数对晶化量的影响,初步探讨了脉冲磁场对非晶合金Fe78Si9B13纳米晶化的作用机制
2)amorphous Fe78Si9B13 alloyFe78Si9B13非晶合金
1.The plastic deformation property of amorphous Fe78Si9B13 alloy was investigated by tension and gas pressure bulging at elevated temperature.通过高温拉伸及胀形实验,研究了Fe78Si9B13非晶合金的塑性变形性能。
3)amorphous Fe_(78)Si_9B_(13) alloy非晶Fe78Si9B13合金
1.The amorphous Fe_(78)Si_9B_(13) alloy was partially crystallized when it was irradiated by CO_2 laser beam with 20mm spot diameter for 20 sec at 250W and 300W as the laser power.在CO2激光散光斑直径20mm的情况下,分别选择在不同功率静置的条件下辐照Fe78Si9B13非晶带实现部分晶化·用穆斯堡尔谱、X射线衍射和扫描电镜对原始非晶样品(Fe78Si9B13)和晶化后样品的微观结构进行了分析·结果表明:在CO2激光散光斑直径一定的条件下(20mm),分别选择激光功率250W和300W辐照非晶Fe78Si9B13样品20s,非晶样品可以实现约6%和9%的晶化·激光辐照非晶Fe78Si9B13合金的晶化相为αFe(Si),样品发生了织构现象,晶粒沿(200)面大量析出·激光晶化相产生在非晶带表面晶化层中·在其他条件一定的情况下,样品的晶化量随着激光功率的增加而增加
4)Fe78Si9B13 amorphous alloy ribbonsFe78Si9B13非晶薄带
1.The Fe78Si9B13 amorphous alloy ribbons with the thickness of 25 μm and the width of 4.5mm、厚25μm的Fe78Si9B13非晶薄带,并用Q800动态热机械分析仪(DMA)测试了非晶薄带的弹性模量、线形变和线膨胀系数,并分析了它们随着退火工艺及测试温度的变化关系。
2.In this paper, Fe78Si9B13 amorphous alloy ribbons with 25 μm thickness and 4.5mm、厚25μm的Fe78Si9B13非晶薄带。
3.In this paper,the influences of frequency and magnetic field intensity on the magnetic induction effect and the impact factor for the changing magnitude of magnetic induction effect of Fe78Si9B13 amorphous alloy ribbons were studied.研究了频率、磁场强度对Fe78Si9B13非晶薄带的磁感应效应及影响磁感应效应变化幅度的因素。
5)Iron[英]['a??n][美]['a??n]Fe
1.Determination of Iron(Ⅲ) in Chinese Herbal Medicine and Tea Based on Fluorescence Quenching of 2,4-Dichro-Phenylfluorone;2,4-二氯苯基荧光酮-Triton X-100荧光熄灭法测定中草药、茶叶中的微量Fe
2.Primary Speciation Analysis of Iron in Edible Flowers;食用花卉中Fe含量及其形态分析
3.Simultaneous Determination of Iron and Platinum by Ridge Regression Atomic Absorption Spectrophotometry;岭回归原子吸收光谱法同时测定Fe和Pt
英文短句/例句
1.The Preparation and Characterization of Iron Oxide, Iron Nitrogen Oxide Thin Films;Fe-O、Fe—N—O薄膜的制备与性能研究
2.Studies on Magnetoresistance in Fe/In/Fe Trilayers;Fe/In/Fe三层薄膜磁电阻效应的研究
3.Structural and Magnetic Properties for Fe mono-layer and Bi-layers on Mo(110);Fe/Mo(110)的多层Fe的结构和磁性的研究
4.Effect mechanism of Fe in Fe-Si_3N_4-C systemFe-Si_3N_4-C体系中Fe元素的作用机理
5.Transform rules between Fe~(3+)/Fe~(2+)in the UV/Fenton systemUV/Fenton体系中Fe~(2+)/Fe~(3+)的相互转化规律
6.The Research on Solid Zn/Fe and Zn/Fe-Si Diffusion Couples and Phase Diagram of Zn-Fe-S;Zn/Fe和Zn/Fe-Si固态扩散偶及Zn-Fe-S三元系相图的研究
7.A number of other minerals are also present in small amounts, e.g.Cu, Zn, Fe.以及少量的Cu、Zn、Fe
8.Prepartion of Super-fine Iron Powder by Use of FeSO_4.7H_2O;FeSO_4.7H_2O制备超微Fe粉的研究
9.Snoek Relaxational Peak in a Fe-Cr-Al Alloy;Fe-Cr-Al合金中的Snoek弛豫
10.Discussion on Fe~(3+) and S~(2-) Reaction;Fe~(3+)与S~(2-)反应的研究
11.The LiNbO_3: Fe Photorefractive Crystal Write-in Slab WaveguideLiNbO_3:Fe晶体中写入光波导
12.Study on Treatment of Diazodinitrophenol Wastewater by Iron-Carbon or Iron-Copper Internal Electrolysis;Fe-C/Fe-Cu内电解处理二硝基重氮酚废水研究
13.Quantum Chemical Study of CO Adsorption on the Fe(111) and Fe(100) Surfaces;CO在Fe(111)和Fe(100)面上吸附的量子化学研究
14.The Research on the Electrodeposition of Fe-Nd-P Alloy Films and Fe-Ce-P Alloy Films in Aqueous Solutions;水溶液电沉积Fe-Nd-P、Fe-Ce-P稀土合金薄膜
15.The Mechanical Alloying of Fe-Ni-Al and Fe-Ni-Ce Systems;Fe-Ni-Al和Fe-Ni-Ce三元合金的机械合金化研究
16.The Isothermal Section Phase Diagrams of La-Fe-Ge and La-Fe-Sn Ternary System at 773K;La-Fe-Ge和La-Fe-Sn三元系合金773K等温截面相图
17.Study on Degradation of Polychlorinated Biphenyls by Ni/Fe and Nanoscale Ni/Fe Bimetallic Particles;Ni/Fe及纳米Ni/Fe对多氯联苯的催化脱氯
18.Micelle Enhance Sensitivity Determination of Fe(Ⅱ) and Fe(Ⅲ) in Water By H-point standard additions method;胶束增敏H点标准加入法测定水中Fe(Ⅱ)、Fe(Ⅲ)
相关短句/例句
amorphous Fe78Si9B13 alloyFe78Si9B13非晶合金
1.The plastic deformation property of amorphous Fe78Si9B13 alloy was investigated by tension and gas pressure bulging at elevated temperature.通过高温拉伸及胀形实验,研究了Fe78Si9B13非晶合金的塑性变形性能。
3)amorphous Fe_(78)Si_9B_(13) alloy非晶Fe78Si9B13合金
1.The amorphous Fe_(78)Si_9B_(13) alloy was partially crystallized when it was irradiated by CO_2 laser beam with 20mm spot diameter for 20 sec at 250W and 300W as the laser power.在CO2激光散光斑直径20mm的情况下,分别选择在不同功率静置的条件下辐照Fe78Si9B13非晶带实现部分晶化·用穆斯堡尔谱、X射线衍射和扫描电镜对原始非晶样品(Fe78Si9B13)和晶化后样品的微观结构进行了分析·结果表明:在CO2激光散光斑直径一定的条件下(20mm),分别选择激光功率250W和300W辐照非晶Fe78Si9B13样品20s,非晶样品可以实现约6%和9%的晶化·激光辐照非晶Fe78Si9B13合金的晶化相为αFe(Si),样品发生了织构现象,晶粒沿(200)面大量析出·激光晶化相产生在非晶带表面晶化层中·在其他条件一定的情况下,样品的晶化量随着激光功率的增加而增加
4)Fe78Si9B13 amorphous alloy ribbonsFe78Si9B13非晶薄带
1.The Fe78Si9B13 amorphous alloy ribbons with the thickness of 25 μm and the width of 4.5mm、厚25μm的Fe78Si9B13非晶薄带,并用Q800动态热机械分析仪(DMA)测试了非晶薄带的弹性模量、线形变和线膨胀系数,并分析了它们随着退火工艺及测试温度的变化关系。
2.In this paper, Fe78Si9B13 amorphous alloy ribbons with 25 μm thickness and 4.5mm、厚25μm的Fe78Si9B13非晶薄带。
3.In this paper,the influences of frequency and magnetic field intensity on the magnetic induction effect and the impact factor for the changing magnitude of magnetic induction effect of Fe78Si9B13 amorphous alloy ribbons were studied.研究了频率、磁场强度对Fe78Si9B13非晶薄带的磁感应效应及影响磁感应效应变化幅度的因素。
5)Iron[英]['a??n][美]['a??n]Fe
1.Determination of Iron(Ⅲ) in Chinese Herbal Medicine and Tea Based on Fluorescence Quenching of 2,4-Dichro-Phenylfluorone;2,4-二氯苯基荧光酮-Triton X-100荧光熄灭法测定中草药、茶叶中的微量Fe
2.Primary Speciation Analysis of Iron in Edible Flowers;食用花卉中Fe含量及其形态分析
3.Simultaneous Determination of Iron and Platinum by Ridge Regression Atomic Absorption Spectrophotometry;岭回归原子吸收光谱法同时测定Fe和Pt
6)Fe/Al 2O 3/FeFe/Al_2O_3/Fe
延伸阅读
Fe-Si alloy分子式:CAS号:性质:含硅0.5%~4.5%的铁硅合金。为硅在铁中的置换固溶体,属立方晶系。饱和磁感应强度为1.6~1.9J,铁损1~8W/kg。除了冲片使用外,常做成薄带,卷绕成铁芯。采用冷轧或进而热处理的方法获取结构(晶粒定向排列)。电力工业中用于电机、变压器等。电子工业中主要用于电源变压器、磁放大器等。