1)DBTT塑-脆转变温度
1.The results show: the Ductile-Brittle Transition Temperature(DBTT) is about-100 ℃,which is lower than those of some other RAFMs; The ultimate strength are 668 MPa at room temperature and 334 MPa at 600 ℃,which are comparable to those of EUROFER97.结果表明:CLAM钢的塑-脆转变温度在-100℃左右,低于国际上其它几种典型的低活化马氏体钢;在室温和600℃时抗拉强度分别为668和334 MPa,类似于EUROFER97的性能。
2)ductile-brittle transition塑脆转变
3)brittle-ductile transition脆塑转变
1.Moreover, the feasibility of brittle-ductile transition of monocrystalline Silion is studied with the method of first principle stress.并用第一原理应力计算方法对单晶硅纳米切削过程中的脆塑转变的可行性进行了研究。
2.In this paper,the mechanism of brittle-ductile transition of glass-ceramics at different low temperatures was studied.本文针对微晶玻璃低温抛光加工过程,研究了低温条件下微晶玻璃的脆塑转变机理,采用维氏硬度计研究了微晶玻璃在不同温度下的硬度以及裂纹的产生、扩展及特征,分析了温度对微晶玻璃脆塑转变的影响。
英文短句/例句
1.Research on Brittle-Ductile Transition Critical Condition of Ultrasonic Vibrition Turning of Optical Glass;光学玻璃超声振动切削脆塑转变临界条件的研究
2.ductile-brittle transition temperature韧性-脆性转变温度
3.embrittlement temperature延性 脆性转变温度
4.Investigation and Application on Ductile-to-Brittle Transition Behavior of Ice;冰的韧脆转变行为研究及其工程应用
5.Abstract: The epoxy plastic (EP) moulding surface of drop hammer die seriously presented embrittlement and deformation while drop pressing.文摘:原有的环氧塑料落压模在使用过程中模具型面脆裂变形严重。
6.Freliminary Investigation of Microcracks in Laboratory Prepared Columnar Ice during Ductile-Brittle Transition人造柱状冰韧脆转变区裂纹的初步研究
7.Ductile-brittle Transition Behavior of Heat-affected Zone in Copper Precipitation Strengthening Steel;铜沉淀强化钢焊接热影响区韧脆转变行为研究
8.Change of Contemporary Human Value Awareness and Fragility of Present World;从价值意识的转变看当今世界的脆弱性
9.Fracture Toughness and Failure Curve of 22NiMoCr3-7 Steel in Ductile-Brittle Transition Range22NiMoCr3-7钢韧-脆转变区断裂韧度及断裂失效曲线
10.FRACTURE TOUGHNESS PREDICTION OF A533B-1 STEEL OVER THE DUCTILE-BRITTLE TRANSITION RANGE BASED ON CONSTRAINT EVALUATIONA533B-1钢韧脆转变区断裂韧度预测的约束评估法
11.Brittle-ductile Transition of PP/EPDM Blend Filled with Nanomullite纳米莫来石填充PP/EPDM共混物的脆韧转变
12.Research on Coefficent of Brittle Stress Drop of Brittle-plastic Rocks脆塑性岩石应力脆性跌落系数的试验研究
13.The alloys occur ductile fracture after annealing.合金热轧态呈脆性准解理断裂,退火后转变为韧性断裂。
14.During the air pressure test, the test temperature shall be higher than the brittle transition temperature of the metal material.气体压力的试验时,试验温度必须高于金属材料的脆性转变温度。
15.I convert the crisp fat in Joe's breakfast bacon into fatty acids and glycerol.我把乔早餐吃的熏肉中的脆肥肉转变成脂肪酸和甘油。
16.The article describes determination of the characteristic values of impact energy and its use such as steel ductile-brittle transition.介绍了冲击能量特徵值的测定及其在钢的冷脆转变等方面的应用。
17.Phosphorus Equilibrium Grain Boundary Segregation and Its Effect on the Ductile-to-Brittle Transition Temperature for a 2.25Cr1Mo Steel;2.25Cr1Mo钢中磷的平衡晶界偏聚及其对钢的韧脆转变温度的影响
18.Research of the Relationship between the Ductile to Brittle Transition and Stacking Fault Energy of High Nitrogen Containing Austenitic Stainless Steel高氮奥氏体钢的韧脆转变与层错能之间的关系研究
相关短句/例句
ductile-brittle transition塑脆转变
3)brittle-ductile transition脆塑转变
1.Moreover, the feasibility of brittle-ductile transition of monocrystalline Silion is studied with the method of first principle stress.并用第一原理应力计算方法对单晶硅纳米切削过程中的脆塑转变的可行性进行了研究。
2.In this paper,the mechanism of brittle-ductile transition of glass-ceramics at different low temperatures was studied.本文针对微晶玻璃低温抛光加工过程,研究了低温条件下微晶玻璃的脆塑转变机理,采用维氏硬度计研究了微晶玻璃在不同温度下的硬度以及裂纹的产生、扩展及特征,分析了温度对微晶玻璃脆塑转变的影响。
4)Ductile brittle transition塑脆转变
1.Except Lamy's suggestion of ductile brittle transition depth D ′, as defined critical normal force F nc can be supposed as a new ductile brittle transition criterion for Ni P plating.利用单摆划痕法的动态加载特性 ,研究了 Ni- P化学镀层本身的塑脆转变。
5)brittleness ductility transition脆-塑转变
6)Brittle ductile transition脆塑转变
1.Based on the types of fracture behavior, the brittle ductile transition cutting model in diamond turning of brittle materials is obtained.根据所产生的裂纹形式得到了脆性材料超精密车削时的的脆塑转变车削模型。
延伸阅读
超导转变温度超导转变温度superconductive transition temperature ChOC吐取)ZhUOnbi即WendU超导转变温度(supe二onductivetlansitio。tem-伴m灿re)超导材料由超导态转变为正常态的温度。加世纪印年代末,美国标准局(NBS)的科学家发现,铅(7 .1卯7K)、锢(3.414 SK)、铝(l.1810K)、锌(0沼匆OK)以及福(0.5200K)5种材料的超导转变温度的复现性均优于hnK,并且有较窄的转变宽度,可以作为测温固定点。1盯6年临时温标(EPI,一76)中利用这5种材料作为该温标的固定点。后来,又增加了一些新的材料:祝(9.邓SOK)、金化锢(O俄巧SK)、金化铝(0.1印SK)、铱(0.“旧OK)、铁(0.工3 OK)和钨(0.0160K)。在rIS一oo中,它只作为近似技术中的参考点。镖器翌纂纂蔚泰杯”‘化繁穿戮
