1)Solid Fraction固相率
1.Relationship between Properties and Solid Fraction in Steel-mushy QTi3.5-3.5 Graphite by Pressure Bonding;钢-QTi3.5-3.5石墨半固态压力复合性能与固相率的关系
2.The results show that with the stirring time prolonging under the condition of temperature-changing arid continuously stirring, the solid fraction increases, the diameter of prim.结果表明:在变温连续搅拌条件下,随着搅拌时间的延长,半固态浆料的固相率提高,初生固相颗粒的直径减小,组织更均匀;经过t道次的轧制,半固态浆料中的液相从固相颗粒间挤出,流向轧件的表面,大部分固相集中在轧件的中心,产生宏观偏析现象,提高固相率可减小偏析程度。
3.The relationship between distribution of graphite particles in the ingot and solid fraction ofmushy wasgotten,and the condition ofacquiring QTi3.5石墨复合材料进行了研究 ,得到了半固态浆料固相率与铸锭中石墨颗粒分布之间的关系 ,确定了获得石墨颗粒均匀分布的 QTi3。
英文短句/例句
1.Quantitative Analysis of Semi-Solid Magnesium Alloy AZ91D's Solid-Phase Rate Based on CA-CCA Method基于CA-CCA方法定量解析AZ91D镁合金半固态固相率的研究
2.Numerical Simulation of Thixoforming of SiC_P/AZ61 Composites under High Solid Volume Fraction高固相率SiC_P/AZ61复合材料触变成形的数值模拟
3.Analysis of Correlation between Growth Quantity and N-Fixation Efficiency of 29 N-fixing Trees29种固氮树种生长量与固氮效率相关性研究
4.The smallest characteristic value corresponds to the lowest natural angular frequency.最小的特征值相当于最低固有角频率。
5.The influence factors of solid-state polycondensation reaction ratePET固相缩聚反应速率的影响因素
6.Preparation, Structure, Photoluminescence and Electrical Resistivity of Solid Sintered Porous SiC;固相烧结多孔SiC的制备、结构、光致发光和电阻率
7.Study on Phase Aberration of the Optics for High Power Solid-state Laser Facility;高功率固体激光驱动器光学元件位相误差研究
8.New Method of Phase Selection of EHV Lines Based on Natural Frequency基于固有频率的超高压线路选相新方法
9.Factors Affecting the Permeability Recovery of Weak Gel Solids/Clay-free Drilling Fluids.影响弱凝胶无固相钻井液渗透率恢复值的因素
10.Creatinine clearance was correlated directly with plasma aldosterone and inersely with renin.肌酐清除率与血浆醛固酮浓度正相关，与肾素水平反相关。
11.Experimental Study and Similarity Analysis of the Axial Profile of Solid Hold-up in the Dense Region of a Coupled Fluidized Bed耦合流化床密相区固含率轴向分布及相似性分析
12.The Ways for Increasing Acidolysis Rate in the Titanium White Production through Eliminating Solid Residue of Acidolysis硫酸法钛白生产中消除酸解残余固相物提高酸解率的途径
13.The Relativity Between Investment of Fixed Assets and Urbanization Rate--A Case Study of Chongqing;固定资产投资与城镇化率相关性——以重庆直辖市为例
14.Distribution Characterizations of Phase Holdups in Gas-Liquid-(Solid) Bubble Column Using Electrical Resistance Tomography采用电阻层析成像技术测量气液（固）鼓泡床相含率的分布特性
15.Measurement Method of Volume Voidage in Dilute Gas-Solid Flow of Fluidized Bed Based on Image Processing流化床气固稀相流动体积空隙率的图像检测方法
16.Studies on Influence Factors of Grafting Ratio of Solid-phase Polypropylene Grafted with Maleic Anhydride聚丙烯固相接枝马来酸酐的接枝率影响因素的研究
17.EFFECT OF COOLING RATE ON γ' PRECIPITATE OF DZ4125 ALLOY UNDER HIGH THERMAL GRADIENT DIRECTIONAL SOLIDIFICATION高温度梯度定向凝固冷却速率对DZ4125合金γ′相的影响
18.Effects of ultraviolet aging on color and translucency of composite resin cements紫外线照射老化树脂黏固剂对色度值及相对透明率的影响
相关短句/例句
High Solid Fraction高固相率
1.Constitutive Model of High Solid Fraction Semi-solid Material;高固相率半固态材料本构模型的研究
3)solid phase efficiency固相效率
1.We demonstrate that the phosphorus doping solid phase efficiency, η ,of a Si∶H can be written as an explicit function of phosphorus phase concentration.证明了ａ－ＳｉＨ磷掺杂固相效率η可表示成磷气相浓度的解析函数，其系数可由磷掺杂饱和极限、悬挂键密度和带尾态电子密度等的实验值决
4)decolorization rate of solid-phase固相脱色率
1.In the experiment of photocatalysis treatment for reactive-purple dye waste water,the index of decolorization rate of solid-phase was first used to replace the conventional decolorization rate of liquid-phase,and the optimum operation conditions of decolorization were as follows.在光催化处理活性紫废液的实验研究中,首先以新建固相脱色率为指标得出脱色的适宜操作条件,即TiO2含量1 g/L、废液初始浓度60 mg/L、设备进气量0。
5)fs-index(fs:fraction solidified)固相率指数
6)solid-phase recycled rate固相回收率
1.Through theoretical calculation and experimental analysis and according to the graphic processing and optimal algorithm,the distribution curves of solid-phase recycled rate and granularity distribution are obtained.通过理论计算和实验分析,并借助于Matlab的图形处理及优化算法,直观地得到了固相回收率和粒度分布的关系。
延伸阅读
电导率(见电阻率)电导率(见电阻率)conductivity d!日nd日O}已电导率(eonduetivity)见电阻率。
