冷凝温度,condensing temperature英语短句,例句大全

冷凝温度,condensing temperature
1)condensing temperature冷凝温度
1.Discussion of the condensing temperature in the standard of SCREW REFRIGERANT COMPRESSORS;《螺杆式制冷剂压缩机》标准中冷凝温度的探讨
2.Some researches in an ice harvester machine are made which indicate that the evaporating temperature is the most significant factor which influence the COP (Coefficient of Performance) of a refrigeration compressor while both the evaporating temperature and the condensing temperature are two main factors.通过对某冰片滑落式冰蓄冷空调系统运行的分析及研究,表明在影响制冷机COP值的两大因素——蒸发温度和冷凝温度中,蒸发温度占主导地位,要提高制冷机运行的COP值应当首先考虑提高制冷机的蒸发温度。
3.By use of such refrigerants,the compressor discharging temperature is almost equal to the condensing temperature,and problems relative to high compressor discharging temperature are avoided.可使工质在压缩过程中始终接近饱和蒸气状态,压缩机排气温度约等于工质的冷凝温度,从而可较好地解决排气温度过热所引起的一系列问题。

英文短句/例句

1.Thermal analysis of CO_2/NH_3 cascade system and optimization of condensing temperatureCO_2/NH_3复叠系统热力分析与冷凝蒸发器冷凝温度的优化
2.Analysis of concrete temperature field considering water pipe cooling考虑水管冷却的混凝土温度场的分析
3.Research on the change of Refrigeration Coefficient with the temperature of Condensation and vaporization;冷凝及汽化温度的变化对制冷系数影响的研究
4.Study on the Influence of Condenser Cooling Water Temperature and Flow Rate on Condensate Sub-cooling Degree凝汽器冷却水温度和流量对凝结水过冷度影响的研究
5.Effect of height of second-stage cooling on concrete thermal creep stress二期冷却高度对混凝土温度徐变应力的影响
6.Research on Mesh Density of Discrete Algorithm for Pipe Cooling Concrete Temperature Field水管冷却混凝土温度场离散算法网格密度研究
7.cold crack temperature低温龟裂温度,冷裂温度
8.Finite Element Analysis of Thermal Stress in Concrete Dams Using Water Cooling Pipes混凝土坝水管冷却温度应力的有限元分析
9.The Analysis and Simulation of Temperature Field and Stress Field in a Sulfur Condenser;硫磺冷凝器温度场应力场耦合分析计算
10.Effect of Condenser Pipe Temperature on Vacuum Cooling of Vegetables凝水管温度对蔬菜真空预冷过程的影响分析
11.Investigation of Direct Contact Condensation of Saturated Steam on Sub Cooled Liquid and 2-dimensional Temperature Distribution;饱和蒸汽在过冷液面直接接触冷凝瞬态特性及二维温度场的研究
12.Cooling Water( 6-10 c)冷却水(温度6－10℃)
13.EFFECT OF COOLING RATE ON γ' PRECIPITATE OF DZ4125 ALLOY UNDER HIGH THERMAL GRADIENT DIRECTIONAL SOLIDIFICATION高温度梯度定向凝固冷却速率对DZ4125合金γ′相的影响
14.A gas condensing boiler is also installed, and is fitted with an outside temperature compensating controller.另外，还安装了蒸汽冷凝锅炉，并且装有室外温度补偿控制器。
15.Experimental Investigation and Numerical Simulation on Air Temperature Distribution around Wire-and-tube Condenser丝管式冷凝器周围空气温度分布的实验研究及仿真
16.Effect of Initial Condition on Temperature Distribution and Steam Condensation Behavior during CMT Drainage;CMT排水过程中初始参数对流体温度分布及冷凝特性影响研究
17.Analytical and Experimental Study of Temperature Field under the Using of Cooling Pipe for Massive Concrete Pier;大体积混凝土桥墩水管冷却温度场分析与试验研究
18.Studies on the Supporting Structure System for Air Cooled Condenser of Big Power Plant under the Temperature Action;温度作用下火力发电厂空气冷凝汽器支架结构体系研究

相关短句/例句

condensation temperature冷凝温度
1.The condensation temperature and evaporation temperature are variational in condensator and evaporator using R22/R142b non-azeotropic mixture refrigerant.R2 2 /R14 2b非共沸混合制冷剂在冷凝器和蒸发器中其冷凝温度和蒸发温度是变化的。
2.Through a theoretical analysis the authors have derived a relationship for calculating the mean condensation temperature of a multi-pressure condenser, which has taken into account the variation of heat transfer factor with the change of condenser construction scheme and cooling water inlet temperature.通过理论分析 ,得出考虑传热系数随凝汽器结构和冷却水入口温度变化条件下多背压凝汽器的平均冷凝温度的关系式 ,分析了各级传热面积和循环倍率对平均冷凝温度的影响 ,并以多背压凝汽器的平均冷凝温度为目标函数 ,得出多背压凝汽器的最优结
3.,air wet-bulb temperature,condensation temperature and relative moisture were conducted.对影响板式蒸发式冷凝器热工性能的主要因素——空气的湿球温度、冷凝温度、相对湿度做了实验研究。
3)condensate temperature冷凝水温度
1.It discusses the error caused by the changes of the condensate temperature in sampling pipe.分析了用于电站锅炉汽包水位测量的差压式汽包水位计测量误差产生的各种原因,并针对取样管冷凝水温度变化对测量误差产生的原因进行了讨论。
4)condenser temperature冷凝器温度
5)temperature gradient condensation温度梯度冷凝
1.The conditions to prepare Chuanxiong (Chinese Traditional Medicine) dropping pills with self-designed experimental machine are studied by the method of temperature gradient condensation.本文采用温度梯度冷凝法,用自制滴丸机对中药川芎滴丸的成形工艺条件进行了试验研究。
6)Condensing-temperature control冷凝温度控制