阴燃温度,smoldering temperature英语短句,例句大全

阴燃温度,smoldering temperature
1)smoldering temperature阴燃温度
1.Case study shows that the smoldering temperature increases with the increase of airflow.结果表明:随着空气流量的增大,阴燃温度是不断上升的,但由于受到反向空气风流的影响,阴燃温度的增长幅度是逐渐变小的;阴燃传播速度却呈现出先增大后减小直至熄灭的变化趋势;在气体流量为零的情况下,燃料仍然可以发生阴燃,而维持阴燃不断传播所需要的氧气量源于反应区域周围气体的扩散。
2)smoldering velocity阴燃速度
1.The effects of airflow velocity are numerically simulated on smoldering velocity and average maximum temperature of smoldering fuel by using the model.应用该模型模拟了来流速度对阴燃速度及平均最高温度的影响,结果表明:首先阴燃传播速度随着来流速度的增大而增大,当风速为0。
3)cathode temperature阴极温度
1.In this paper are discussed the cathode temperature,such as the principles of experiment and the results including the layout,distribution of cathode temperature,its fitting to the lamp and the ballast,etc.本文讨论了阴极温度分布的实验原理和阴极温度分布的结果以及灯与镇流器的配合等。
2.Simulation and measurement result indicate that magnetic field influence the beam current of MIG, and the beam current of the MIG depends on the cathode temperature and space charge effect.模拟和测量结果显示磁场对MIG的束流有影响,MIG的束流也与阴极温度和空间电荷效应有关系。

英文短句/例句

1.It was found that with increasing the cathode temperature the arc velocity decreases.实验发现,随着阴极温度的增加,电弧的后退速度下降。
2.Using optical method the retrograde velocities of vacuum arcs in magnetic fields were measured as a function of the cathode temperature for Cu, Al and316 stainless steel used as the cathode material.本文用光学方法测定了在横向磁场中真空电弧后退运动的速度和阴极温度的关系。
3.Experimental Research for Resistivity vs.Temperature of Zr-W Cathode;Zr-W阴极电阻率随温度变化的实验研究
4.Relation between Sintering Temperature of Cathode Blocks and Versus Oxygen Concentration in Electrolytic Tantalum Powders阴极块烧结温度与电解钽粉氧含量的关系
5.Effects of superheat and current density on electrolysis expansion performance of semi-graphitic cathode at low temperature过热度和电流密度对半石墨质阴极低温电解膨胀性能的影响
6.Effect of annealing temperature on photo-induced cathodic protection of aligned TiO_2 nanotube thin films热处理温度对TiO_2纳米管阵列薄膜光生阴极保护性能的影响
7.Preparation and properties of low temperature curable cathodic electrodeposition coatings低温固化阴极电泳涂料的制备与性能
8.Applied for marking filament,cathodes,setting rod at H.t,electrode etc.用于制作灯丝，发射阴极，高温定型杆，电极等。
9.Composite Cathode and Anodic Current Collecting Problem of Intermediate-Temperature SOFC;中温型SOFC复合阴极和阳极汇流问题的研究
10.The cathode at the left is raised to a high temperature by the heater, and electrons evaporate from its surface.左边的阴极被灯丝加热到高温，同时电子从阴极表面蒸发出来。
11.The mercury indicated 37℃ in the shade.温度计的水银柱表明在阴处温度为摄氏37度。
12.Observation of cathode temperature-drop phenomenon caused by diode board-current with IR thermometer用红外测温仪观察二极管板流引起的阴极降温现象
13.The thermometer gives 30 c in the shade.温度计显示阴处为30 摄氏度。
14.The thermometer gives 30° in the shade.在阴凉处温度计上是摄氏三十度。
15.temperature-compensated Zener diode温度补偿齐纳二极管
16.subarctic conditions,temperatures亚北极的环境、温度.
17.Standard for test method of cathodic disbonding of pipeline coatings subjected to elevated temperatures管道防腐层高温阴极剥离试验方法标准
18.Study of Hollow Cathode Dischage Using in Speedy High Temperature Sintering Process;空心阴极等离子快速高温烧结工艺研究

相关短句/例句

smoldering velocity阴燃速度
1.The effects of airflow velocity are numerically simulated on smoldering velocity and average maximum temperature of smoldering fuel by using the model.应用该模型模拟了来流速度对阴燃速度及平均最高温度的影响,结果表明:首先阴燃传播速度随着来流速度的增大而增大,当风速为0。
3)cathode temperature阴极温度
1.In this paper are discussed the cathode temperature,such as the principles of experiment and the results including the layout,distribution of cathode temperature,its fitting to the lamp and the ballast,etc.本文讨论了阴极温度分布的实验原理和阴极温度分布的结果以及灯与镇流器的配合等。
2.Simulation and measurement result indicate that magnetic field influence the beam current of MIG, and the beam current of the MIG depends on the cathode temperature and space charge effect.模拟和测量结果显示磁场对MIG的束流有影响,MIG的束流也与阴极温度和空间电荷效应有关系。
4)combustion temperature燃烧温度
1.The effects of nitrogen purity and pressure,combustion temperature,diluents content and the porosity were studied during the process.研究结果表明:只要控制反应中的工艺参数,就可以采用自蔓燃得到不同相含量的Si3N4粉体;考虑到燃烧温度(Tcom),在氮化硅粉体的合成过程中,涉及到3个反应机制:低温机制,中温机制,高温机制;氮气压力下硅粉的自蔓燃合成反应,必须要引入Si3N4稀释剂,来控制反应温度和反应速度,获得不同相含量的粉体;NH4Cl在反应中分解,为反应提供了NH3,并与硅粉反应;压坯气孔率控制在30%~70%,否则反应不能进行。
2.The influence of pressure, diameter and preheating temperature of green-pellet on combustion temperature (T_c) during preparing Al-Ti-C master alloy and the microstructure of synthesized product has been investigated.采用自蔓延高温合成(SHS)技术制备出了一种用于铝及铝合金晶粒细化的AI-Ti-C中间合金,并研究了压坯密度、压坯直径、预热温度对自蔓延高温合成Al-Ti-C中间合金时的燃烧温度及微观组织结构的影响。
3.The effect of CaO/MgO ratios on the efficiency of sulfur fixation was studied under the different combustion temperatures and the quantities of the sulfur-fixing agents.通过对不同燃烧温度和固硫剂添加量下CaO/MgO之比与固硫率之间关系的研究发现,燃烧温度相同而CaO/MgO之比不同时,固硫率不同;燃烧温度不同时,最佳CaO/MgO之比也不同,而且随温度升高而向CaO增多、MgO减少的方向变化。
5)burning temperature燃烧温度
1.Influence of cigarette smoking parameters on burning temperature and delivery levels of smoke constituents;抽吸参数对卷烟燃烧温度及主流烟气中某些化学成分的影响
2.With action of catalyst it increases burning temperature, decreases energy consumption.由于催化剂的作用，这种火盖可提高燃烧温度、降低能耗、改善燃烧废气带来的环境污染。
3.The burning temperature and explosive pressure of thirteen kinds of hydrocarbon gases was computed under various original conditions.对于压力容器内的烃类气体与空气的混合物，按球面逐层绝热燃烧模型，编制了电算程序ＤＵＴＧＢ１，在不同初始条件下计算了１３种烃类气体的燃烧温度与爆炸压力，用本文实验值及文献值与之比较，燃烧温度的计算偏差为１１。
6)light-off temperature起燃温度
1.Under simulated exhaust conditions,the catalytic activity is evaluated by using the light-off temperature(the temperature of 50% conversion simplified as T_(50)) and the temperature of 90% conversion(T_(90)) for the three pollutants CO、HC and NO_x.在模拟条件下,以起燃温度和气体转化效率90%时的温度为评价指标测定HC、CO及NOx的三效催化活性。
2.La_(1-x)Ce_xFe_(1-y-n)Co_yRu_nO_3 were prepared by the sol-gel method to study the catalytic activity and evaluated by using the light-off temperature (the temperature of 50% conversion simplified as T_(50)) and the temperature of 90% conversion (T_(90)) under simulated exhaust conditions for the three pollutants CO? HC and NO_X.为研究Ru改性的铁基钙钛矿体系的催化性能,用溶胶-凝胶法分别制备了不同x、y、n值的La1-xCexFe1-y-nCoyRunO3系列化合物,在模拟条件下,以起燃温度和气体转化效率为90%时的温度为评价指标测定了HC、CO及NOX的三效催化活性。
3.The results showed that the catalysts containing Ce xZr 1-xO 2 solid solutions have higher conversion as well as lower light-off temperature compared with that containing pure CeO 2.4 O2 催化剂性能最佳 ,HC、CO、NO的转化率在A/F =14 6时分别为 97 33%、89 5 2 %、10 0 %;新鲜催化剂的起燃温度分别为 186、180、185℃ ,高温处理后起燃温度分别为 2 49、2 41、2 46℃。